spray angle meaning in Chinese
喷射角
喷雾角度
喷雾锥角
Examples
- Normal - temperature fog machinery spray angle measuring system based on machine vision
怎样选择保护地植保机械 - ( 4 ) the droplets diameter of the combined spin - flow pressure spray drying are between 30um and 150um and the ranges of the droplets are narrow . the average diameter of the droplets is between 50 um and 100 um and the spraying angle can be adjusted from 30 to 180
( 4 )采用旋流式组合压力喷嘴雾化后的液滴直径大都分布在30 150um之间，雾滴分布范围较窄，其雾化的平均液滴直径在50 100um左右，压力喷嘴的雾化角度可在150 180范围内。 - ( 2 ) base on the analysis of the atomizing principles of spray nozzle , mathematical model of combined spin - flow pressure spray drying was set up and the essential parameters such as spraying pressure , liquid quantity , temperature , spraying angle , inject distance , particle diameter and distribution , hollow diameter for several materials in normal conditions by experiment and ldv
( 2 )对旋流式组合压力喷嘴喷射雾化机理加以分析，建立了旋流式喷嘴雾化的数学模型，采用冷态试验法并借助激光雾滴测试等实验装置对喷嘴的雾化参数(如雾化压力、喷液量、料液温度、雾化角、雾距、雾滴直径和分布以及喷嘴的空芯半径等)进行测量和计算。 - The optimal parameters of making high silicon content aluminum alloys is : spray height is 220 - 230mm , spray angle is 30 ? the scanning velocity of atomizer is 30mm / s , the original offset of the substrate is 30mm , rotation velocity of the substrate is 120rpm , spray gas pressure is l . ompa , the diameter of the delivery tube is 3 . 6mm , the drawing velocity of the substrate will be adjusted on - line with a plc on the basis of the spray
通过对多层喷射沉积原理及工艺参数的研究，得出制备al - 22si - 3cu - 1mg合金的最佳工艺参数为：喷射高度为220mm - 230mm ，基底转速为120rpm ，雾化器扫描速度为30mm / s ，基底下降转速依据喷射情况由智能控制器进行实时调整，喷射角度为30 ，初始偏心距为30mm ，导流管直径为3 . 6mm ，雾化气压为1 . 0mpa 。 - It can make sprinkler of water feeding install on strap or on sand inlet of double disk and adjust spraying angle of sprinkler according to real condition ; the water will spray on falling sand that makes it form sand curtain ; it sprays water on hot sand equably and extends exchanging time of water and hot sand . 4
根据现场情况，加水喷头可设在进砂皮带上，或设在双盘的进砂口处，调整喷头的喷洒角度，使水喷向由下落的砂子组成的砂帘，将水尽可能预先均匀得喷洒在热砂上，增加水与热砂的有效热交换时间。